I flipped the wood over and cut the other side at 45". So, I was able to get the other face flat by referencing the face which was already flat.įinally, I used my miter saw to cut one end of the wood at 48". Luckily, the cypress had one flat face even though it still needed to be sanded. Then, I ran the live edge cypress through my surface planer to get each side flat. Additionally, I find myself using my table saw less and less now that I have this Festool track saw. Again, the wood did not have a straight side so the table saw was not an option. Next, I used my festool track saw to rip the wood down the middle with 2 passes rather than all at once. Also, you can pay the wood dealer you purchase it from to mill it for you.įirst, I used my Japanese hand saw to cut off the end of the Cypress. The live edge cypress did not have a straight side to rest against my miter saw fence. Therefore, it was unsafe to cut with anything but a hand saw. If you don't have the tools to mill wood, find a local sawmill to mill it for you. It is vital to use wood with straight sides, square ends, and a flat surface. Ultimately, it reduces frustration and makes the project so much easier. During one of my visits to pickup cypress wood for a different project, he gave me a raw piece of new growth cypress. I liked the light color, grain pattern, and the fact it was in the trash pile. I have a locally owned Cypress sawmill not too far from where I live.
0 Comments
Leave a Reply. |